November 19, 2026 · 4 min read

Paver Sealing: What It Does and When Your Pavers Need It

Pavers on a driveway, walkway, patio or pool deck take a lot of wear. Sealing puts a clear protective coat over them. Here is what that coat does, the signs it's time, and how to get ready if you're in Port Orange or a nearby town.

What sealing does for pavers

A paver sealer is a clear coating that soaks into the surface of the pavers. Once it cures, it puts a layer between the pavers and whatever lands on them: oil from a car, leaves, spilled drinks and dirt tracked in from the yard.

Some sealers keep a natural look and some give a wet look that brings the color back out. Many also help hold the sand in the joints in place. Either way, the goal is pavers that are easier to keep clean and look even from one end of the driveway to the other.

Signs your pavers are due

Look at the pavers in full daylight. Faded or patchy color, stains that come back soon after you clean them, and a dry, chalky look all point to a surface with nothing protecting it.

Check the joints too. If the sand between the pavers is washing out, or weeds keep coming up through the gaps, refilling the joints and then sealing helps keep them in place.

A quick test: pour a little water on a paver. If it beads on top, some sealer is still there. If it soaks in and darkens the paver right away, the surface is likely bare.

Clean first, then seal

Sealer locks in whatever is on the surface, so the pavers need to be clean before it goes on. That means a thorough wash to lift dirt, growth and stains, and a look at the joints.

After the wash, the pavers have to dry fully. Sealer put on damp pavers can turn cloudy, so the timing depends on the weather and how long the surface takes to dry.

Seabreeze Sparkle Pressure Washing does the pressure cleaning and the sealing, so one crew handles the whole job from start to finish.

How long sealer lasts

It depends on the product, how much sun and traffic the area gets, and how the pavers are looked after. Many homeowners have their pavers resealed every few years, and a driveway that sees cars every day usually needs it sooner than a patio out back.

Between sealings, rinse spills and oil spots quickly and sweep leaves off before they leave a mark.

Getting ready for your appointment

Move cars, grills, furniture and planters off the pavers before the visit, and plan to keep them off for a while after sealing so the sealer can cure. Turn off any sprinklers that hit the area.

When you call, tell us where the pavers are (driveway, walkway, patio or pool deck), roughly how big the area is, and whether they've been sealed before. Photos help. We serve Port Orange, Daytona Beach, Ormond Beach, New Smyrna Beach, Ponce Inlet and nearby towns, and we're open Monday to Sunday, 6am to 9pm.

Questions we hear

Do pavers have to be cleaned before sealing?

Yes. Sealer traps whatever is on the surface, so dirt, stains and growth should come off first, and the pavers should be fully dry.

Can I drive on my driveway right after it's sealed?

Not right away. Sealer needs time to cure, and the wait depends on the product. We'll tell you when it's ready for foot traffic and cars.

How can I tell if my pavers were sealed before?

Pour a little water on them. Beading means some sealer is still there. Water that soaks in and darkens the paver right away means the surface is likely bare.

Does sealing change the color of my pavers?

It can. Some sealers keep a natural look and others bring out a richer, wet look. Ask about the finish when you call.

Get started

Need a hand in Port Orange?

Call Seabreeze Sparkle Pressure Washing at (386) 213-9539, or use the quote form on this page.

Call now · (386) 213-9539

Get a quote

Seabreeze Sparkle Pressure Washing, serving Port Orange and nearby towns.

Or call us at (386) 213-9539